Change the presser foot to the button
sewing foot.
Position the work under the foot. Place the
button in the desired position, lower the foot.
Select zig zag pattern. Adjust the stitch width to
"2.5-4.5" according to the distance between the
two holes of the button.
Turn the handwheel to check that the needle
goes cleanly into the left and right holes of the
button.
Before sewing, press the Auto-lock button to
sew reinforcement stitches automatically at the
beginning and at the end of the stitch.
If a shank is required, place a darning needle
on top of the button and sew.
For buttons with 4 holes, sew through the
front two holes first, push work forward and
then sew through the back two holes.
Move the drop feed control to " " to lower
the feed dogs.
2.5~4.5
2.5~4.5
Button Sewing
Basic Sewing Procedures
To Next Page
Loading...
