Bernina Bernette 340 deco - Getting Ready to Embroider; Raising the Presser Foot; Threading the Machine

Getting ready to Embroider
11
Raising the Presser Foot
The presser foot lifter raises and lowers the presser foot.
The presser foot can be raised about 6 mm (1/4") higher than the
normal up position. This will help you to place the embroidery hoop
under the foot.
Threading the Machine
Raise the presser foot lifter. Turn the handwheel counterclockwise to
bring the needle to its highest position.
1. Presser foot lifter
Hold the thread with both hands and pass the thread around under
the thread guide plate (A). Then draw the thread down through the
right channel of the thread guide plate (B).
2. Thread guide
Firmly draw the thread around the bottom of the thread guide plate
and up to the thread take-up lever (C).
3. Thread guide plate
1
2
3
2
B
A
3
C