Mastering
Your
BERNINA
®
BERNINA
®
Sergers
MASTERING YOUR BERNINA
®
SERGER 2/15/03
102
Notes
©2003 BERNINA® of America, Inc. Permission to copy granted only to Authorized BERNINA
®
Dealers
Multi-Purpose Foot with Guide -
Corded Piping
Following the instructions in your owner’s manual, thread the serger for
a 4-thread overlock stitch using both needles. Adjust all settings for a
balanced stitch.
Set stitch length to 3.5mm.
Attach the Multi-Purpose Foot and Guide following the directions in the
instruction manual for the Multi-Purpose Foot with Guide. Note: 700D
and 800DL also need the Attachment Base.
Insert the filler cord into the guide.
Wrap the bias strip around the cord and place the wrapped cord in the
groove under the foot.
Serge the covered cord.
Mount the sample.
Fabric ......................................... mediumweight cotton bias strip, 2” x 8”
Other ................................................... 12” length of
3
/8” cotton filler cord
Needle ............................................................................. 80/12 Universal
Thread ................................................................... 4 cones serger thread
Presser Foot ........................................... Multi-Purpose Foot with Guide
Stitch ............................................................................ 4-thread overlock
To Next Page
Loading...
