Bernina Sergers - Thread Rolled Hem

Mastering
Your
BERNINA
®
BERNINA
®
Sergers
MASTERING YOUR BERNINA
®
SERGER 2/15/03
98
Notes
©2003 BERNINA® of America, Inc. Permission to copy granted only to Authorized BERNINA
®
Dealers
Two-Thread Rolled Hem
Attach the 2-thread adapter (upper looper converter) to the upper
looper. Note: This is an optional accessory for the 700D.
Following the instructions in your owner’s manual, thread the serger
for a 2-thread flatlock stitch. Adjust settings as directed.
Pull the rolled hem lever towards you.
Adjust the stitch length to 1.75mm.
Set cutting width at 2mm (normal).
Place the fabric under the presser foot and serge along one 6” edge,
trimming about
1
/8” from the raw edge.
Return stitch length and thread tension levers to normal.
Trim and mount the sample.
Fabric ................................................................................ batiste, 4” x 6”
Needle ............................................................... 70/10 Sharp or Microtex
Thread ................................................ 2 cones lightweight serger thread
Presser Foot .............................................................................. standard
Stitch ................................................. 2-thread rolled edge (right needle)