16
/ Accessory
TELESCOPIC GLIDES
The telescopic glides fi t any shelf level and work
with the wire shelves provided as standard equi-
pment.
Fitting the glides
• Locate the two spring clips at the front and
back of the glides.
• Locate the pin on the glide that indicates the
back.
• Choose the right level and position the
telescopic glide near the upper wire.
• Gently insert the front spring clip on the glide.
• Insert the rear spring clip on the glide.
• Pull and push each glide to ensure the correct
installation and smooth operation.
• Extract both glides to the fully extended
position and place the shelf over them, making
sure it’s accurately placed between the rear
pin and the front pin.
Removing the glides
1 - Locate the two spring clips at the front and
back of the glide.
2 - Gently pull down the front spring clip.
3 - Pull the glide away from the oven side - be
careful not to strain the clip.
4 - Repeat steps 2 - 3 on rear spring clip to remo-
ve glide.
1
2
3
4
To Next Page
Loading...
