What to do if there is Quartz synchronization error on Berthold castxpert LB 452 Measuring Instruments?
If you are experiencing issues with quartz synchronization on your Berthold Measuring Instruments, contact service if the error persists.
What to do if the fill level display deviates in Berthold Measuring Instruments?
If the fill level display on your Berthold Measuring Instruments is deviating, check the detector and calibration values. Also check the source age and irradiation level, replace the detector if needed.
Why is the count rate too low on Berthold castxpert LB 452 Measuring Instruments?
If the count rate is too low on your Berthold Measuring Instruments, first check if the shielding is correctly opened. Ensure the lock is in the OPEN position. Verify and optimize the alignment to correctly focus the radiation on the detector. Offset any objects in the beam path. If the source is old, consider replacing it.
What to do if no data is being received in the control center via Ethernet from Berthold Measuring Instruments?
If you are not receiving data in the control center via Ethernet with your Berthold Measuring Instruments, activate the output of measurement data over the network in the Data Logger menu under Network settings.
How to resolve software exception on Berthold castxpert LB 452?
If you are experiencing a software exception with your Berthold Measuring Instruments, carry out a software update. If the error persists, contact the service.
What to do if Decay compensation fails on Berthold Measuring Instruments?
If decay compensation is failing on your Berthold Measuring Instruments, contact service.
What to do if Calibration is not monotonic in Berthold castxpert LB 452?
If the calibration is not monotonic on your Berthold Measuring Instruments, check the calibration table.
How to fix count rate stability out of bounds on Berthold castxpert LB 452 Measuring Instruments?
If the count rate stability is out of bounds on your Berthold Measuring Instruments, ensure that no other factors influence the count rate during the read-in (e.g., disruptions in the beam path). Carry out the adjustment again (twice, if needed). The error is automatically cleared.
What to do if WD off occurs in Berthold Measuring Instruments?
If the watchdog is disabled on your Berthold Measuring Instruments, remove the debug jumper.
How to resolve device data inconsistency found on Berthold castxpert LB 452?
If your Berthold Measuring Instruments are showing an issue with device data, carry out a factory reset.
Details on adhering to instructions and ensuring safe and reliable operation of the EVU.
Highlights risks of improper use, including electric shock and personal injury.
Specifies the minimum requirements and groups of personnel for safe handling and maintenance.
Explains the functional principle and components of the radiometric measurement setup.
Step-by-step guide for installing the EVU, including safety precautions.
Instructions for setting up current outputs on basic and extension modules.
Description of the main display screen and its elements during operation.
Guide to identifying and resolving common issues with the EVU.
Detailed list of system error codes, their descriptions, and corrections.
General| Detector Type | Silicon Drift Detector (SDD) |
|---|---|
| Interface | USB, Ethernet |
| Power Supply | 100-240 V AC, 50/60 Hz |
| Measurement Principle | X-ray fluorescence (XRF) |
| Measurement Time | 10 to 300 seconds (depending on application) |
| X-ray Tube Voltage | up to 50 kV |
To Next Page
