Bertin Technologies ALPHAGUARD DF2000 - Remote and Stationary Monitoring

67 WWW.BERTIN-INSTRUMENTS.COM
USER MANUAL
Remote and stationary monitoring
For remote access of the AlphaGUARD as well as for the integration of one or more
AlphaGUARD
units
into real time online networks, suitable solutions for specific
requirements are available. These solutions are based on publicly available IT
services and approved transmission components. Specifically developed software
modules ensure a reliable interaction of the AlphaGUARD units with the applied IT
interfaces.
Data transmission can be adapted according to the requirements of the
application (e.g. outdoor cabinets for outdoor use, automatic ventilation or
heating for extreme weather conditions, specified data transmission solutions,
etc.). Depending on the application, the following equipment is needed:
x AlphaGUARD
x COM Server (accessory for LAN integration) or DACC (LAN integration for
real time monitoring, mobile phone network connection (4G) optional)
x
Outdoor cabinet (if needed)
x DataVIEW PRO Software (intuitive software for comfortable data read
out and parametrization), or
x DataEXPERT 10 software (Fig. 4). This software eases system management
by showing all technical and radiological events of the connected
probes in real time. The users have access to the system’s overview, and
all the instruments’ parameters can be adjusted using its remote setup
functions.
There is two types of d
ata connection:
1. Manual read-out and parametrization by using LAN or internet
connection, with a COM Server and DataVIEW PRO software.
2. Real time online monitoring by using LAN, internet connection or 4G
mobile phone network, with a DACC (Data Acquisition & Configuration
Computer
) and DataEXPERT 10
software.
10.10.1 Manual remote read-out and remote parametrization
This solution ensures the access to the AlphaGUARD for configuration purposes
and manual data downloads. The simple online mode of DataVIEW PRO can be
used as well (Attention:
there is no alarm functions available in the simple online
mode). The DataVIEW PRO software must permanently be running and the online
routine has to be started manually for each AlphaGUARD unit part of the network.