Bestop 51117 - Folding the Top down

Step Two
With a razor knife, cut the stitching on the old door covers and remove them from the frames.
Step Three
Start with the front of the door cover and locate the cut outs in the fabric for the door pins. Insert the door pins through the cut outs in
the fabric and place the "First" corner into the pocket sewn into the fabric. Work around the door, slipping each corner into each corner
of the elastic band. It may be necessary to unzip the upper window before sliding the elastic over the last corner.
First Corner
Door Pins
Third Corner
Last Corner
Second Corner
Adhesive Hook Strip
Snap Cover to Diagonal Rod
Figure 3
Step Four
After the fabric door covers are on the frames, install the adhesive hook on the door frame to match up with the loop strip sewn into the
fabric cover. Snap the cover to the diagonal rod of the frame. Use a pair of scissors to cut a hole in each door for the handle and
reinstall the handle. Make sure that you replace it the way it came off.
Folding the Top Down
Step One
Unsnap the rear and side curtains and unzip the rear curtain zippers. Roll the rear curtain to the inside and secure it to the top with the rear
curtain straps. Unsnap the top from the body and remove both the Vertical and Horizontal Rods.
Step Two
Fold the side curtain and lay it on top of the Top, folding along the seam. Then fold the rear curtain up over the side curtains (see Figure
4). Push the Front Bow toward the Rear Bow.
Step Three
Unfasten the Top from the windshield and lower the Top onto the vehicle as you push both Bows down and to the rear (see Figures 5 and
6). Smooth out wrinkles and fold the Top in half from front to rear. You may then fold the Top to the back.