20
1
GENERAL INFORMATION
CONOSCENZA DEL VEICOLO
Capacità di riempimento RR 125 ENDURO - MOTARD
• serbatoio carburante..........................................5,7 (lt)
di cui lt di riserva ....................................................1 (lt)
• olio motore .......................................................... 1,2 (lt)
Sospensione anteriore
RR 125 ENDURO - MOTARD
• forcella idraulica con steli di Ø 41 mm
Olio contenuto nei gambi:
- destro
(livello con tubo a fine corsa 185 mm) ..................... 400 cc
- sinistro
(livello con tubo a fine corsa 185 mm) .................... 400 cc
Sospensione posteriore RR 125 ENDURO - MOTARD
• monoammortizzatore con regolazione precarico
molla
• Corsa ammortizzatore....................................... 52 mm
Freno anteriore RR 125 ENDURO - MOTARD
• a disco Ø 260 mm con comando idraulico.
Freno posteriore RR 125 ENDURO - MOTARD
• a disco Ø 220 mm con comando idraulico.
Filling capacity RR 125 ENDURO - MOTARD
• fuel tank ................................................................ 5,7 (lt)
including reserve of ................................................ 1 (lt)
• engine oil .............................................................. 1,2 (lt)
Front suspension
RR 125 ENDURO - MOTARD
• hydraulic fork with 41 mm. Ø rods
Oil content in shafts:
- right
(oil level with tube at the end of its stoke at 185 mm) .. 400 cc
- left
(oil level with tube at the end of its stoke at 185 mm) ...... 400 cc
Rear suspension RR 125 ENDURO - MOTARD
•
single shock absorber with spring preload
adjustment
•
shock absorber travel ....................................
52 mm
Front brake RR 125 ENDURO - MOTARD
• disk-type with hydraulic control
Ø 260 mm
Rear brake RR 125 ENDURO - MOTARD
• disk-type with hydraulic control
Ø 220 mm
To Next Page
Loading...
Need help?
General
