2
OPERATION
31
GB
LUBRICANTS
To maximize the vehicle’s performance and ensure many years of trouble-free opera-
tion, we recommend using the following products:
Note
It is essential that all renewals should be performed with the products listed in the
table above.
RUNNING-IN
The running-in period lasts approximately 15 hours, during which it is advisable to:
1 During the first 3 hours of operation the engine should only be used to approxi-
mately 70 percent of its power. In addition, the engine speed should not exceed
7,000 rpm.
2 In the subsequent 2 hours of running, the engine can be exploited up to 90% of
its power.
3 Use the vehicle after properly warming up the engine.
4 Avoid travelling at constant speed (changing the speed causes the different com-
ponents to bed in evenly and more quickly).
This procedure should be followed each time piston, piston rings, cylinder, crankshaft
or crankshaft bearings are replaced.
WARNING:
Replace the transmission oil after the first 3 hours or after 15 l of mixture.
•
Always use high-octane unleaded gasoline and specific synthetic oil (mixture at 1.6%).
• After using the vehicle on rough ground for the first time, carefully check the
tightening of all nuts and bolts.
PRODUCT TYPE SPECIFICATIONS
OILMIXTURE PANOLIN OFF ROAD 2T RACE 10W/50
GEAR AND CLUTCH OIL PANOLIN OFF ROAD 4T SYNTH 10W/40
BRAKE OIL BRAKE FLUID DOT 4
CLUTCH ACTUATOR OIL BRAKE FLUID DOT 5.1
FORK OIL FUCHS 1091 (SAE 2,5)
TIE ROD GREASE PANOLIN SPECIAL GREASE NLGI 2
LIQUID COOLANT PANOLIN ANTI-FROST MT-325
To Next Page
Loading...
