2
OPERATION
26
GB
CHECKS BEFORE AND AFTER USE
For safe driving and long vehicle life you should:
1 Check all fluid levels.
2 Check the correct operation of the brakes and brake pad wear (page 48).
3 Check pressure, general condition and thickness of tread.
4 Check that the spokes are properly tightened.
5 Check the tensioning of the chain (page 61).
6 Check the adjustment and the operation of all the cable controls.
7 Inspect all the nuts and bolts.
8 With the engine running, check the operation of the headlight, the rear and
brake lights, the indicators, the warning lights and the horn.
9 Wash the motorcycle thoroughly after off-road use (page 67).
RUNNING IN
The running-in period lasts approximately 15 hours, during which it is advisable to:
1 During the first 3 hours of operation the engine should only be used to ap-
proximately 50 percent of its power. In addition, the engine speed should not
exceed 7,000 rpm.
2 For the next 12 hours of operation the engine should only be used to about
75 percent of its power.
WARNING
After the first 3 hours change the engine and gear oil.
This procedure should be followed each time piston, piston rings, cylinder, crankshaft
or crankshaft bearings are replaced.
To Next Page
Loading...
Need help?
General
