BETAFPV Cetus Lite - Advanced Settings; Re-Bind for Quadcopter

132
8. Advanced Settings
If quadcopter and remote control radio transmitter cannot be binded successfully, the
pilot may need to re-bind. This can happen when replacing new electronic parts of the
quadcopter during maintenance or upgrading the remote control radio transmitter. The
steps are as follows:
● Power on the quadcopter and wait for its system to load completely;
● Use a screwdriver to lightly press the button on the quadcopter and the status light
on the quadcopter turns green and starts to flash;
● Power on the remote control radio transmitter and wait for its system to load
completely;
● Lightly press the BIND button on the bottom of the remote control radio transmitter
with a screwdriver. The power indicator will flash red;
● If re-bind is successful, quadcopter status light will change to blue.
Additional advanced settings are available in case of special operations.
8.1 Re-Bind for Quadcopter
Note: The re-binding of the remote control radio transmitter and the quadcopter may not be
successful after pressing the BIND button of the remote control radio transmitter once. In this
situation, pilot needs to press the BIND button a second time to complete the binding.
Bind Button