BETCO BPS28 - GENERAL INFORMATION AND PREPARATION; 1.5 FOREWORD; 1.6 MACHINE APPLICATION; 1.7 UNPACKING THE MACHINE

5
1.5 FOREWORD
The purpose of this manual is to inform the operator of the basic rules, safety rules and criteria which must be
observed when using, adjusting and maintaining the machine. The machine has been developed and has been
developed and manufactured to ensure excellent performance and the utmost comfort and ease of operation in a
variety of working conditions. Before delivery, the machine has been checked at our factory and by our dealer to
make sure it is handed over to you in perfect working order: To maintain the machine in this condition and ensure
problem-free operation, it is essential to follow the routine maintenance instructions given in this handbook.
1.6 MACHINE APPLICATION
The machine, composed of a brush and a suction system, is to be used EXCLUSIVELY to clean dry surfaces. Any
other use could be cause of damage to people or things and is therefore PROHIBITED.
1.7 UNPACKING THE MACHINE
Unpack the machine with the utmost care; avoid carrying out any operation that that could damage it. Once it has
been unpacked, check whether it is damaged. If you notice that it is not in correct working order, DO NOT use it
and inform your dealer. For packaging and transport purposes, some parts and accessories are supplied
disconnected from the machine. To assemble them,carefully follow the instructions given in the relevant sections.
Contents of package:
1 Machine
1 Side brush
1 Instructions and spare parts manual.
2 Ignition keys
1 Declaration of conformity
1 Warranty slip
1 Handle's fixing key
If one of the above mentioned parts is missing, please inform your dealer right away.
Take care to keep the packaging materials (bags, cartons pallets, hooks, etc) out of the reach of
children.
For security during transport, the ignition keys and
Handle's fixing key have been fixed to the handle.
2.1 PREPARING THE MACHINE FOR OPERATION
2.1.1 MOUNTING THE SIDE BRUSH
- Switch the brush lift lever to OFF.
- Remove the screw from the side brush drive shaft.
- Fit the brush on the shaft.
- Screw on the screw and washer.
2.1.2 MOUNTING THE HANDLEBAR (FIG. 2A)
Locate the handle at the right height, by using one of the fixing holes (Pos.1
or Pos.2). Fix the handle to the frame by means of 2 screws “A.”
!
NOTE
Fig. 2A