9
5.3 FILTER MAINTENANCE
CLEANING THE FILTER
The filter is one of the machine main components. It is essential for the best results from your machine. If you notice
that dust forms when the machine is at work, check the filter.
The filter is cleaned as follows:
A. Press and release the lever of the appropriate filter shaker, (#6, Fig. 3). The lever operates a rod that will unclog
the filter. Repeat this operation 5 or 6 times.
B. Apart from the filter shaker, it is advisable every now and again to remove the machine’s filter and clean it out
with a blast of air or a vacuum cleaner.
For this purpose,the filter is removed as follows:
- Remove the rear bin/back drawer.
- Lift the blocking handle (#1, Fig. 4).
- Rotate the handle, in order to remove the filter
- Remove the filter (#3, Fig. 4) while holding up the filter shaker rod.
- To remount the filter (#3, Fig. 4) carry out the operation in reverse order.
- ATTENTION: The filter features an arrow that shows you the direction in which it should be fitted.
DUSTY ENVIRONMENTS: If you are using the machine in a particularly dusty environment (cement factories,
sawmills, marble processing factories),it is wise to use the filter shaker more frequently.
REPLACING THE FILTER
Every 200 hours of work, the filter must be replaced. Follow the operations listed in point B.
After the filter has been remounted, make sure the gasket and filter are dust tight.
WASTES MUST BE DISPOSED OF IN ACCORDANCE TO THE LAW.
Fig. 4
To Next Page
Loading...
