7
4.2 CORRECT OPERATION
After you have become familiar with the operations required to start the machine, you can actually start using the
sweeper. To obtain the best results, it is always wise to take a few precautions. These will help you to get the best
from your machine and reduce damage to a minimum.
In particular:
- Do not use the machine to clean up wires, ropes or straps or pick up water and other liquids.
- When using the machine on light but bulky material (sheets of paper, leaves,etc.), raise the front part of the
machine by pressing down the handlebar so that the machine can tackle the rubbish.
- Operate the filter shaker at the end of your work (see the "Panel Filter"section").
- Make sure the center brush is correctly regulated (see the section on adjusting the centre brush).
4.3 CLEANING THE WASTE BINS
Before carrying out this operation, make sure all parts are off.
(*) ATTENTION: WASTES MUST BE DISPOSED OF STRICTLY IN ACCORDANCE WITH THE LAW.
4.3.1 FRONT BIN/DIRT HOPPER
Lift the hood.
Lift and turn the two bin locks.
Grasp the handle and remove the bin by pulling it upwards.
Empty the bin (*).
To put the bin back in place:
Put the bin back in the machine from the top.
Turn and lower the two locks.
4.3.2 REAR BIN/BACK DRAWER
Lift and turn the two bin locks.
Grasp the handle and pull the bin out of the machine.
Empty the bin (*).
To put the bin back in place:
Fit the bin back into the machine.
Turn and press the two locks.
To Next Page
Loading...