Better BT-1 - Emphasis and Double-Strike Modes

BT-1 user manual
Page 22 of 70
[Note]
λ
λ
λ
This command affects printing in standard mode. However, the
setting is always effective.
When underline mode is turned on, the printer does not underline
90° clockwise-rotated characters.
Double-width and double-height commands in 90° rotation mode
enlarge characters in the opposite directions from double-height and
double- width commands in normal mode.
[Default]
n=0
[Reference]
ESC !
,
ES
C
ESC G n
[Name]
Turn on/off double
-
strike mode
[Format]
ASCII:
ESC G n
Decimal:
27 71 n
1B 47 n
Hexadecimal:
0≤n≤255
[Range]
[Description]
Turns double
-
strike mode on or off.
λ
λ
λ
λ
When the LSB of n is 0, double-strike mode is turned off.
When the LSB of n is 1, double-strike mode is turned on.
Only the lowest bit of n is enabled.
[Note]
Printer output is the same in double-strike mode and in emphasized
mode.
[Default]
n=0
[Reference]
ESC E n
ESC E n
[Name]
Turn emphasized mode on/off
[Format]
ASCII:
ESC E n
Decimal:
27 69 n
1B 45 n
Hexadecimal:
0≤n≤255
[Range]
[Description]
Turns emphasized mode on or off
λ
λ
λ
λ
When the LSB of n is 0, emphasized mode is turned off.
When the LSB of n is 1, emphasized mode is turned on.
Only the least significant bit of n is enabled.
[Note]
This command and
ESC !
turn on and off emphasized mode in the
same way. Be careful when this command is used with ESC !
[Default]
n=0
[Reference]
ESC !
利用 pdfFactory Pro 测试版本创建的PDF文档 www.pdffactory.com