Better BT-1 - Spacing, Width, and Upside-down Modes

BT-1 user manual
Page 23 of 70
ESC SP n
[Name]
Set right
-
side character spacing
[Format]
ASCII:
ESC SP n
Decimal:
27 32 n
1B 20 n
Hexadecimal:
0≤n≤255
[Range]
[Description]
Sets the character spacing for the right side of the character to [n×0.125
mm (n×0.0049”)].
[Note]
λ
The right-side character spacing for double-width mode is twice the
normal value. When characters are enlarged, the right-side character
spacing is n times normal value.
λ
This command does not affect the setting of Kanji characters
This command sets values independently in standard mode.
λ
[Default]
n=0
ESC SO n
[Name]
Select Double Width mode
ASCII:
[Format]
ESC SO n
Decimal:
27 14 n
1B 0E n
Hexadecimal:
[Description]
Select Double Width mo
de
To turn double width off, use
LF
or
DC4
command.
ESC DC4 n
[Name]
Disable Double Width mode
[Format]
ASCII:
ESC DC4 n
Decimal:
27 20 n
1B 14 n
Hexadecimal:
[Description]
Disable Double Width mode
ESC { n
[Name]
Turns on/off upside
-
down printing mode
[F
ormat]
ASCII:
ESC { n
Decimal:
27 123 n
1B 7B n
Hexadecimal:
0≤n≤255
[Range]
[Description]
Turns upside
-
down printing mode on or off.
λ
λ
λ
When the LSB of n is 0, upside-down printing mode is turned off.
When the LSB of n is 1, upside-down printing mode is turned on.
Only the lowest bit of n is valid.
[Note]
利用 pdfFactory Pro 测试版本创建的PDF文档 www.pdffactory.com