Better BT-1 - Buffer Count and Parameter Saving

BT-1 user manual
Page 52 of 70
(pL+(pH×256))bytes.
λ
a specifies setting values for the positions to start printing and cutti
ng
a
1
2
Function
Setting value for the positions to start the printing.
Setting value for the positions to start the cutting.
λ
m specifies the direction of the adjustment.
m
Function
0,48
1,49
Specifies a forward paper feeding direction
Specifies a backward paper feeding direction.
λ
λ
nL and nH specifies the setting value to [(nL+nH×256)×0.125 mm].
The adjustment value for the print starting position (a=1) is affected
with the following commands:
GS FF
λ
The adjustment value for the paper cutting position (a=2) is affected
with thefollowing commands:
GS V m n
[Default]
All adjustment values are set to “0”.
(At the factory setting, the print starting position and the cutting position
are set to the head position and the cutter position respectively when the
BM sensor detects the BM.)
[Reference]
GS FF
,
GS V
FS C (for CB65C)
[Name]
Start receive buffer count
[Format]
ASCII:
FS C
Decimal:
28 67
1C 43
Hexadecimal:
[Description]
Start receiving buffer count.
FS S (for CB65C)
[Name]
Start send buf
fer count
[Format]
ASCII:
FS S
Decimal:
28 83
1C 53
Hexadecimal:
[Description]
Send count of receive buffer, include this command's 2 bytes.
FS s (for XBLY)
[Name]
Save print parater
[Format]
ASCII:
FS s
Decimal:
28 115
1C 73
Hexadecimal:
[
Description]
Save print parater. (only for XBLY)
利用 pdfFactory Pro 测试版本创建的PDF文档 www.pdffactory.com