Beurer FT 78 - Electromagnetic Compatibility; Unit Description and Display

15
ments as a basis for comparison when taking measurements in the
event of a suspected high temperature.
• This thermometer is intended for measuring the temperature in the
ear. Do not use this thermometer for measurements in other parts
of the body.
• Replace the protective cover after each use to ensure an accurate
measurement and prevent cross contamination.
• The thermometer may only be used with protective caps from Beurer;
other protective caps may result in faulty measurements. If you have
run out of protective caps, contact the manufacturer or retailer for
replacements.
• Consult a doctor if you believe your medical condition to be poor.
IMPORTANT
• The device is not shockproof. Do not allow it to be dropped and pre-
vent any high impact stress on the device.
• Avoid bending the device.
• Do not take the device apart and do not modify it in any way.
• If this device is used according to the instructions for use, it is not
necessary to recalibrate it regularly. If you still have any questions,
please take the complete device to the retailer.
Notes on electromagnetic compatibility
• The device is suitable for use in all environments listed in these instruc-
tions for use, including domestic environments.
• The use of the device may be limited in the presence of electromag-
netic disturbances. This could result in issues such as error messages
or the failure of the display/device.
• Avoid using this device directly next to other devices or stacked on
top of other devices, as this could lead to faulty operation. If, how-
ever, it is necessary to use the device in the manner stated, this de-
vice as well as the other devices must be monitored to ensure they
are working properly.
• The use of accessories other than those specifi ed or provided by the
manufacturer of this device can lead to an increase in electromagnetic
emissions or a decrease in the device’s electromagnetic immunity; this
can result in faulty operation.
• Failure to comply with the above can impair the performance of the
device.
4. Unit description
1234
5
1 2 3 4
5
1 Protective cap
2 LCD display
3 ON/OFF/memory button (
)
4 Battery compartment
5 Start button (
)
1 Measurement symbol
2 Ear symbol
3 Battery symbol
4 Temperature unit (°C or °F)
5 Temperature display
If the measurement symbol (
) and the ear symbol ( ) are visible on
the LCD display, the device is ready to take a measurement.
If (
) is shown on the LCD display, the batteries need to be replaced.