24
Step 2: Fill the water tank
1. Remove the motor unit
4
upwards.
2. Insert the filter
5
into the water tank
9
using the filter holder
8
including the water level sensor
6
.
3. Fill the water tank
9
up to the “Max.” mark
7
with cold tap water or distilled water. The water tem-
perature should not exceed 40°C. Do not fill the water tank
9
above the “Max.” mark
7
.
4. Now put the motor unit
4
back on the water tank
9
.
NOTICE
When inserting the filter holder
8
incl. filter
5
and water level sensor
6
, make sure that the round hole of the filter holder
8
is on the small
raised area on the bottom of the water tank.
Step 3: Allow the filter to become saturated
To ensure optimum humidification output, allow the filter
5
to absorb
water for 30 minutes before switching on the air humidifier (the water
level may fall below the “Max.” mark
7
during this process).
30
min
Step 4: Switch on the air humidifier
1.
Insert the mains plug into a suitable socket. Ensure that the cable
does not pose a trip hazard.
2.
Press the ON/OFF button
11
to switch on the air humidifier. During
initial use, the air humidifier will be in Auto mode A (see section “7.3
Setting the fan speed/mode” ) by default.
3.
The LED light ring
2
switches on automatically. The LED light ring
2
shows the current air humidity of the room using colours (see section
“7.5 LED light ring”). The current relative humidity of the room is shown
on the display
12
after a few seconds.
4. As soon as the water in the water tank is used up, the air humidifier
switches o automatically and the water tank indicator
21
lights up
on the control panel. If the water tank is empty, no humidity values
are shown. Now either refill the water tank
9
with water or switch
on the filter drying function as required (see section 8.1 on the filter
drying function).
To Next Page
Loading...
