25
Step 5: Set additional functions
You can now optionally set the following functions:
Target humidity, fan speed/mode, timer function and LED light ring.
For more information on the individual functions, see sections 7.2 to 7.5.
Step 6: After use
1. Disconnect the mains plug from the socket after each use.
2.
Empty any remaining water from the water tank
9
. Do not leave water
in the water tank
9
when the device is not in use.
3. Allow the fi lter
5
to air dry when not in use or use the fi lter drying
function from time to time after use (see section “8.1 Filter drying
function”).
If you want to reposition the air humidifi er, pull the mains plug out of the
socket and empty the water tank
9
to avoid overfl owing. When carrying
the air humidifi er, make sure that you hold the device with both hands at
the bottom of the water tank
9
.
7.2 Setting target humidity
If desired, you can optionally set a target air humidity on the air humidifi er.
The target humidity indicator
13
shows the currently set target humidity (40 %, 50 % or 60 %).
If no value lights up in the target humidity indicator
13
, the humidifi er humidifi es the air until a humidity of
70 % is reached and then switches o . In order to avoid overhumidifi cation of a room, we recommend that
you select a humidity between 40–60 %.
1. Use the target humidity button
14
to select your desired target humidity.
2. The selected target humidity will light up in the target humidity indicator
13
. If no value lights up in the
target humidity indicator
13
, the target humidity is set to 70 %. As soon as the target humidity is reached,
the air humidifi er switches o automatically.
In order to achieve the desired target air humidity as quickly as possible, we recommend
keeping the windows and doors closed during use, as dry outside air could slow down
reaching the target air humidity.
7.3 Setting the fan speed/mode
The air humidifi er has three fan speeds ( I, 2 and 3 ) and two modes ( AUTO mode A and NIGHT mode
SL
).
To Next Page
Loading...
