Orbis – Operation
23
Priority
In this menu the function of the function button of the chairman microphone unit is set.
Normal:
All active microphones of the delegate units will be cleared and the mircophone of the chairman micro-
phone unit will be turned on. The function button of the chairman microphone unit will illuminate green.
If there are more chairman microphone units in the system, their function button will flash green,
because only one chairman can activate the function button.
The delegates can turn on their microphone again, when the priority mode has been terminated. The
microphone of the chairman unit, which was automatically activated when priority was started, remains
active until the chairman turns it off via the function button.
Mute:
All active microphones of the delegate units are temporarily muted (microphone button is flashing
green) when the chairman is speaking. The function button of the chairman microphone unit will
illuminate green. When the chairman ends the priority mode, all previously active delegate micro-
phones will be reactivated. Microphones that were voice-activated, will be cleared and remain
cleared after the priority mode is finished. The microphone of the chairman microphone unit which
was automatically activated, remains active until the chairman turns it off via the microphone button.
Normal and Mute deactivated:
In this case, a command string is output via the RS 232 interface and the function button is used in
conjunction with a media control system.
Volume
The “Volume” menu is used to adjust the volume of the loudspeakers of the microphone units. The
volume can be displayed from 0 to 10 or by turning the rotary encoder .
The volume is always displayed by default when other settings are completed on the menu or when
the rotary encoder has not been operated for more than 5 seconds.
To Next Page
Loading...
