Beyerdynamic QUINTA Series - ~J Commands - Chairperson;Delegate and MU Zone Configuration

22 System Configuration Commands
3.4 ~J commands
Configure Chairperson/Delegate functionality
Configure MU Zone
Important Note
Please use this command only in unicast mode! The unicast mode can be set with the
M command, which addresses a certain MU.
The ~J 4 command only changes the MU functionality. In addition to the MU
functionality, the CU stream reservation protocol should be considered as there is
normally a stream reservation for every chair-device. See the S command in chapter
3.6 for further information.
~J is used to make important settings that are stored directly in the MU, including
whether the MU acts as a chairperson or delegate, as well as the MU zone. These
settings are retained even throughout power cycles.
Communication direction
Controller -> CU
Syntax
Description
~J 4 n
Configure chairperson/delegate functionality
~J 5 m
Configure MU Zone
Parameters
Description
n
0 = delegate // 2 = chairperson
m
00 = MU Zone 1
01 = MU Zone 2
02 = MU Zone 3
03 = MU Zone 4