Beyerdynamic QUINTA Series - c Commands - Ethernet TCP;IP Configuration

32 System Configuration Commands
3.8 c commands
Ethernet TCP/IP configuration
This command group is used to make important Ethernet TCP/IP configuration.
Important Note
Please note that the IP and gateway address must be entered in reverse byte order as
hexadecimal numbers; thus the reverse order refers only to the number blocks (one
byte) and not to the individual numbers!
Communication direction
Controller -> CU
Syntax
Description
c
Get: MAC, IP, Subnet mask, Gateway, DHCP
status
c 2 a
Sets IP address
c 3 a
Sets Subnet mask
c 4 a
Sets Gateway address
c 5 f
Enable/Disable DHCP
c 6 1422
Apply & save the new configuration
permanently to memory
Parameters
Description
a
Addresses (resp. IP, Subnet mask, Gateway) as
hexadecimal number blocks (one byte)
IMPORTANT:
IP and gateway address must be entered in
reverse byte order.
f
0 = disabled // 1 = enabled