Beyerdynamic QUINTA Series - Page 76

76 Microphone Mode Commands
7.4 Remembering Mic Channel (Channel Memory)
The so-called channel memory can be activated so that the mic channels remain
assigned unchanged when the CU is restarted.
It is possible to route the individual channels discretely to the outputs of the CU. In such
a case it is very important that the MUs remain on the correct channels even after
restarting the CU.
v - Channel Memory Status (8 bits)
bit 7
6
5
4
3
2
1
bit 0
N.U.
N.U.
N.U.
N.U.
N.U.
N.U.
N.U.
Channel Memory
bit 7-1 N.U.: not in use, unimplemented bit
bit 0 Channel Memory: the assignment of the channels is saved
1 = ON
0 = OFF
Example
Communication direction
Controller -> CU
Syntax
Description
E 104 v
Write the value v at register 0x104
Parameters
Description
v
Channel Memory Status (8 bits)
Activate/Deactivate Remembering Mic Channels
Transmit:
E 104 1<CR>
This command activates Channel Memory. This will
continue to refer the channels to the same MUs when
the CU is restarted.
Receive:
<CR><LF>
>
Transmit:
E 104 0<CR>
This command deactivates Channel Memory. This
allows the MUs to be assigned to four channels when
the CU is restarted.
Receive:
<CR><LF>
>