Beyerdynamic QUINTA Series - Page 77

77 Microphone Mode Commands
7.5 MU individual Volume (Channel Volume)
In order to adjust the volume of the individual MUs (immediate volume change), it is
necessary to directly address the DSP registers, which are responsible for the volume of
the corresponding upstreams.
Note
This command is of the command form which addresses the DSP, reads it or writes into
its registers as shown in chapter 8.
It should be briefly mentioned that this command can also be used in conference mode
to set the volumes of the individual channels. However, this makes little sense, since the
channels are assigned to other MUs in constant alternation, so that the adjustment of
the Volume Master (see chapter 8.2.1) is completely sufficient.
Communication direction
Controller -> CU
Syntax
Description
P s v
Set individual MU stream volume
Parameters
Description
s
Individual stream volume register
[ channel 1: 0x60
channel 2: 0x61
channel 3: 0x62
channel 4: 0x63 ]
v
Volume
[range: 0x00 0x32]
(The higher the number, the lower the volume.)