DF MANUAL INSTALLATION
Manual version 3.0 - North America (15-07-2014) en-13
en
3. Connect the unit to the mains power supply.
c Make sure the unit’s power supply voltage matches
the local mains voltage.
The unit’s power supply voltage is displayed on the
type plate.
4. Install the control panel and (any optional) connections to
external controls.
5. Complete appliance installation.
6. Turn the mains power supply on and check that the unit is
working properly.
General instructions
Some parts of this section only apply to certain models.
Where this is the case, it will be indicated. If no specific model
is referred to, then the description applies to all models.
n Make sure that you perform all installation
operations that are applicable to your unit.
Check the type plate and consult the manual if in
doubt about the model or type of your unit.
n During the installation period, protect the unit
against damage and penetration of dust, cement, etc..
You can, for instance, use the packaging for
protection.
See also:
2.4 "Hanging the unit up" on page 14
2.5 "Connecting the unit to the central heating system" on
page 16
1 "Connecting the mains supply" on page 1
2.7 "Installing the control panel and external controls" on
page 21
2.8 "Unit finishing" on page 27
2.9 "Switching on and checking operation" on page 29
To Next Page
Loading...