BIG TREE TECH KNOMI 2 - Z Tilt Adjust Macros (printer.cfg)

15
WWW.BIGTREE-TECH.COM
If there is no QGL but there is a Z_TILT function, you can follow the settings below :
[gcode_macro QUAD_GANTRY_LEVEL]
gcode:
SET_GCODE_VARIABLE MACRO=_KNOMI_STATUS VARIABLE=qgling VALUE=True
Z_TILT_ADJUST
SET_GCODE_VARIABLE MACRO=_KNOMI_STATUS VARIABLE=qgling VALUE=False
001
002
003
004
005
ADDING RELEVANT MACROS