Shenzhen Big Tree Technology Co., Ltd.
BIGTREETECH
20 / 22
6. Login as: biqu, password: biqu.
6.2 Compile MCU Firmware
1. After SSH is successfully connected to the device with CB1 installed, enter in the
terminal:
cd ~/klipper/
make menuconfig
Compile the firmware with the corresponding motherboard configuration, here is
the Manta M4P example:
* [*] Enable extra low-level configuration options
* Micro-controller Architecture (STMicroelectronics STM32) --->
* Processor model (STM32G0B1) --->
* Bootloader offset (8KiB bootloader) --->
* Clock Reference (8 MHz crystal) --->
* Communication interface (USB (on PA11/PA12)) --->
To Next Page
Loading...
