BIGTREETECH SKR CR6 V1.0 User Manual

SKR CR6 V1.0 mannul SHENZHEN BIGTREE TECHNOLOGY CO., LTD.
2 / 8
1.Product introduction
BIGTREETECH SKR CR6 V1.0 is a motherboard developed by the 3D printing team
of Shenzhen BIG TREE Technology Co., Ltd. to upgrade your CREALITY CR-6 SE
3D printer.
SKR CR6 V1.0 is a direct replacement for the motherboard on the CREALITY CR-6
SE. This printer has an extruder and uses 4 TMC2209 stepper drivers.
2. Main Features
1) The main control adopts 32-bit ARM-level Cortex-M3 series with 72MHz main
frequency STM32F103RET6 chip;
2) Equipped with highly modular open source firmware Marlin2.0, which is
convenient for users to DIY and reopen
To avoid the worries of not being able to master the core code;
3) Marlin2.0 uses powerful development tools, Visual Studio Code integrated
development environment: supports online debugging, which is more helpful for
product development and performance optimization, and uses C/C++ language
development, which has a low development threshold;
4) The PCB board wiring is rigorous and beautiful, and has been specially optimized
for heat dissipation;
5) Use a dedicated power chip to support 12-24V power input;
6) Support BIGTREETECH-3.5 inch TFT color touch screen, LCD12864 screen,
CR-6 original screen;
7) The system supports languages such as simplified Chinese and English, which can
be switched by itself;
8) Upgrade the configuration firmware via SD card, the operation is simple,
convenient and efficient;
9) Using high-performance MOSFET tube, the heat dissipation effect is better;
10) The use of removable fuses makes the replacement process easier;
11) Support connecting to a computer for printing or using SD card to print offline;
12) Reserved dual Z-axis printer

BIGTREETECH SKR CR6 V1.0 Specifications

General

Brand	BIGTREETECH
Model	SKR CR6 V1.0
Category	Computer Hardware
Language	English