Shenzhen BIGTREE technology co., LTD.
BIG TREE TECH
1. If you want to use a motor drive current of more than 0.8A, it is
recommended to use a fan to actively cool the drive chip.
2.Do not remove the heat sink unless necessary. If it is to be
removed, please ensure that the thermal conductive silicon film fits
the bottom of the heat sink during installation, so as not to cause
short circuit
3. The wiring must be performed when the power is off.
Please make sure the wiring is correct before power on to avoid
damage.
4. Please note that the jumper cap is correctly inserted.
Should you have any issues, please don't hesitate to contact us. We
strive to provide you with the best quality products and services. If
you have any good comments or suggestions, please feel free to
share with us. Thank you for choosing BIGTREETECH products!
To Previous Page
Loading...
Need help?
General
