Binatone DECT Combo Plus Single - Page 60

58
12.5
12.512.5
12.5 Set
Set Set
Set the
the the
the Auto
Auto Auto
Auto P
PP
Prefix
refixrefix
refix on your Cordless Handset
on your Cordless Handseton your Cordless Handset
on your Cordless Handset
You can set the phone to detect the start of a dialling number and
replace it with another number.
You can enter up to 5 digits for the number to be detected, which can be
replaced with an auto prefix number of up to 10 digits.
1. From the home screen, press
M .
2. Press + \-to ADVANCED SET
ADVANCED SETADVANCED SET
ADVANCED SET and then press M to select.
3. Press
+ \-to AUTO PREFIX
AUTO PREFIXAUTO PREFIX
AUTO PREFIX and then press M to select.
4. Press
M again to enter DETECT DIGIT
DETECT DIGITDETECT DIGIT
DETECT DIGIT.
• The last stored detect number is displayed (if any).
5. Enter the number you want to be detected (maximum 5 digits) and
then press
M to confirm.
• A confirmation tone is played.
6. Press + \-to PREFIX
PREFIXPREFIX
PREFIX and press M to select.
•
The last stored prefix number is displayed (if any).
7.
Enter the number you want the detected number to be replaced
with (maximum 10 digits) and then press
M to confirm.
• A confirmation tone is played.
8. Press O to return to standby mode.
Note:
Note:Note:
Note: If the detect digit is not entered (blank), the prefix number will be
automatically added to the pre-dial number after T is pressed.
For numbers starting with *, # or P, the prefix number will not be added
to the pre-dial number after
T is pressed.