WR3000N 300M Wireless N Router
- 24 -
Step 2: For the configuration of the wireless adapter, please choose “Enter a PIN from my
access point” in the configuration utility of the WPS as below, and enter the PIN code of
the Router into the field after “Access Point PIN”. Then click Next.
The WPS Configuration Screen of Wireless Adapter
)
Note:
The default PIN code of the Router can be found in its label or the WPS configuration screen as
Figure 4-2.
c). You will see the following screen when the new device successfully connected to the
network.
)
Note:
1) The WPS LED on the Router will light green for five minutes if the device has been
successfully added to the network.
To Next Page
Loading...
