BINDOMATIC 101 DFS - Technical Specifications; General and Output Capacity; Spine Width and Sheet Capacity

13
9. Specifications
General: The Bindomatic 101 DFS is a semi-automatic high-speed thermal binding machine that
uses only Bindomatic DFS document covers.
Output capacity: 400 - 1600 documents per hour depending on the spine width. The number of
documents that can be put into the machine simultaneously is shown in the table below
and depends on the spine width. The corresponding output speed is stated at the
bottom line in the table.
1.5 mm 3 mm 6 mm 9 mm 12 mm 15 mm
max 4 pcs. max 3 pcs. max 2 pcs. max 1 pc. max 1 pc. max 1 pc.
1600/h 1200/h 800/h 400/h 400/h 400/h
Paper size: A4, 210 x 297 mm
Spine width and The table below shows approximately how many sheets of 80 g paper the covers can
capacity: hold for each spine thickness.
1.5 mm 3 mm 6 mm 9 mm 12 mm 15 mm
1-15 16-30 31-60 61-90 91-120 121-150
Jogging: The sheets of paper in the set are automatically jogged on three sides during the binding
process. No pre-jogging is necessary.
Output capacity: 8 - 50 documents depending on the spine width.
Binding temperature: 165°C
Warm-up time: 2-3 minutes depending on the ambient temperature and local variations in the power
supply voltage.
Energy-saving mode: 4 hours after last document is bound. (Can be set to 15 minutes.)
Voltage: 230 VAC +/- 10%
Power consumption: Stand by 137 W mean value
binding 140 W mean value
power saver 7 W
heating up 630 W
Environment: Temperature 10 - 35°C, humidity 15 - 90% RH.
Dimensions: Length 475 mm
Width 511 mm
Input height 325 mm
Total height 360 mm
Weight: 28 kg