4
• Quick Guide
• Operator’s Manual
• Mains cable
Preparations
1. Check that the items listed above are all included.
2. Remove the Bindomatic 101 DFS from the
packaging materials as described in the instructions
printed on the outside of the box.
3. Put the machine in its place (e.g. on a table).
Remove transport protection.
4. Plug the mains cable first into the machine and then
into the wall socket.
5. Press the button on the machine marked with the
symbol .
6. Check that the Bindomatic 101 DFS starts and that
the following message is shown on the display:
To change language, see chapter 5.1.
7. After you have read the Operator’s Manual and under-
stand how to use the product, put the Manual and Quick
Guide in the holder at the rear of the machine.
Your Bindomatic 101 DFS is now ready for use.
2. Installation
Besides the binding machine, the packaging should contain the following:
MEASURE DOCUMENT
SEE PICTURE 1
Holder for Operator’s Manual
and Quick Guide
To Next Page
Loading...