3
1. DESIGNATED USE
BINKS airless pumps are used exclusively to output and apply spray material. Any materials can be
sprayed, if they are approved by spray material manufacturers for use with airless spraying equip-
ment. These include:
• Water-thinnable lacquers and paints
• Solvent-based lacquers and paints
• Base paints and primers
• Micaceous iron ore
• Zinc-rich paints
• Epoxy and polyurethane paints
• Oils
• Liquid synthetic materials
• Wax-based underbody sealant materials
• Low-solvent and solvent-free spray material
Please observe the working guidelines and safety instructions supplied by the spray material manu-
facturer.
You should avoid using abrasive, granular spray material. Such spray material can
cause heavy wear and tear on the valves and packing sets of the material pump, and
on the nozzles used on the airless gun.
ATTENTION !
BEFORE STARTING UP PUMP FILL UP LUBRICATION FLUID
FOR WATERBORNE PAINT: 0114-014871
FOR SOLVENT PAINT: 0114-009433
To Next Page
Loading...
