BIO RAD 680 - Page 55

51
1-2-14. UPLD (Upload the protocol data)
<command>: "UPLD"
Upload the protocol data
<arguments>: <up load protocol number>
<cmd args>: <up load protocol number>: 1 to 66 (1 to 64 for Endpoint protocol, 65&66 for
kinetic protocol)
Example: EIA.READER UPLD 1 <cr>
<response>: ”ERE”<space><error code><space><protocol data><cr>
1-2-15. DOWNLD (Download the protocol data)
<command>: "DOWNLD"
Download the protocol data
<arguments>: <down load protocol number><space><protocol data>
<down load protocol number>: 1 to 66 (1 to 64 for Endpoint protocol, 65&66 for
kinetic protocol)
<protocol data>: Down load protocol data(see “1-4 Protocol data”)
<response>: ”ERE”<space><error code><cr>
1-2-16. UTSE (Upload the TSE assay parameters)
<command>: "UTSE"
Upload the TSE assay parameters
<arguments>: <TSE type>:0= for TSE parameters / 1=for TSE EQ parameters
Example: EIA.READER UTSE 0 <cr>
<response>: ”ERE”<space><error code><space><TSE or TSE eq assay parameters><cr>
1-2-17. DTSE (Download the TSE assay parameters)
<command>: "DTSE"
Download the TSE assay parameters
<arguments>: <TSE type><space><TSE or TSE eq assay parameters>
<TSE type>: 0= for TSE parameters / 1= for TSE eq parameters
<TSE assay parameters>: Down load TSE assay parameters
(see”1-5 TSE and TSE eq assay parameters”)
<response>: ”ERE”<space><error code><cr>
1-2-18. URPD (Upload Raw Plate Data)
<command>: "URPD"
Upload Raw Plate Data
<arguments>: <type><space><memory number><space><data type>[<space><read
number of kinetic >]
<cmd args>: <type>:Data type(Endpoint= 0, Kinetic= 1)
memory number>: Memory # (Endpoint: 1 to 10, Kinetic: 1 or 2)
<data type>: Data type (Header= 0, Full Data= 1)
<read number of kinetic>: Reading number of kinetic (0, 1 -> 30) Optional for
Kinetic
It is only valid for the <data type>=1
Zero (“0”) means that its parameter is inactive.
Example: EIA.READER URPD 0 1 1 0<cr>
<response>: ”ERE”<space><error code><space><Raw plate data><cr>
<Raw plate data>: See ”1-6. Upload Raw Plate Data format”
1-2-19. DRPD (Download Raw Plate Data)
<command>: "DRPD"
Download Raw Plate Data
<arguments>: <raw plate data>
<raw plate data>: See “1-7. Download Raw Plate Data format”
<response>: ”ERE”<space><error code><cr>