To Remove Data:
1. To remove data in the bottom hand box, click on <Remove>.
2. Highlight the data or item in the right hand box that you wish to remove.
3. Click on <Remove> and a pop-up window will ask if you really want to remove this data. If you do,
click <Yes> and the system will proceed to remove the information. When you are done, click on the
<Exit> button in the center and this will take you back to the regular Atomlab program.
NOTE: If there is already data in a patient file, you must delete that patient in the backup before you can
transfer from the original data.
NOTE: To back-up “procedures” you must save the Isotope information to the backup before transferring the
procedures.
SETUP INSTRUCTIONS 2-18
To Next Page
Loading...
