biodex ATOMLAB 950 - Select Wipe

6-5 WIPE TEST
6. In the Available Isotopes list, highlight an isotope and click on <Add to Area>. The isotope name
will now be displayed in the lower box. If desired, highlight additional isotopes on the Isotope List
and add them to the lower box. To remove an isotope from the box, highlight the isotope in the
lower box and click on <Remove From Area>.
7. Set the trigger level.
NOTE: The trigger level is factory set to 100%. The 100% refers to the NRC trigger levels for different
isotopes. If you want tighter control, lower the trigger level. Use the scroll to the right of the trigger level to
select a different percentage.
8. Click on <Save> in the screen tool bar to save the new wipe area. The new wipe area should now be
shown on the Wipe Area Setup screen.
9. Click on <Close> to return to the Wipe Counting screen with the new area displayed in the Area
Name box.
To Delete A Wipe Area
1. To delete an existing Wipe Area, at the Operation screen click on <Wipe>. The Wipe Counting
screen should now be displayed.
2. Click on the <Define Wipe Area> icon at the bottom of the screen. The Wipe Area Setup screen
should now be displayed.
3. If the currently selected wipe area is the one you want to delete, proceed to step 5. To select another
wipe area to delete, click on <Open> in the screen tool bar. The Wipe Area Selection List should now
be displayed.
4. Double-Click on the desired wipe area. The selected wipe area should now be displayed on the Wipe
Area Setup screen.
5. Click on <Delete> in the screen tool bar.
6. Click on <Yes> to delete.
7. Click on <Close> to return to the Wipe Counting screen. The next wipe area on the Wipe Area
Selection List should now be displayed in the Area Name box.
Select Wipe
To Select an Existing Wipe Area
1. To select a wipe area that has already been entered into the system, at the Operation screen click on
<Wipe>. The Wipe Counting screen should now be displayed.
2. Click on the <Select Wipe> icon at the bottom of the screen. The Wipe Area Selection list should now
be displayed.
1. INTRODUCTION