1. After saving a Thyroid Uptake as described above, click on the <Report> icon in the primary tool
bar. The Report Generation screen should be displayed.
2. Click on the desired parameters, including Time/Activity for Thyroid Uptake, then key in the
Technologist name, dose activity and any comments to be printed on the report.
3.
Click
on
<Preview>
if
you
want
to
preview
how
the
report
will
look
when
it
is
printed.
4.
Click
on
<Print>
to
print
the
report.
5. Click on <Close> to return to the Thyroid Uptake screen.
NOTE: Results can be listed in rads or in grey units of measure. See Section 2, “System Set-Up.”
6.
Click
on
<Print>
to
print
the
report.
7. Click on <Close> to return to the Manual Mode screen.
4-13 THYROID UPTAKE
1. INTRODUCTION
To Next Page
Loading...
