Biolight Q5 - Setting Spo

Patient Monitor User’s manual
9-4
condition and move the probe to other appropriate position.

For Masimo SpO
2
The Masimo module is intended to monitor the PR, SpO
2
, PI of patients.
The following figure shows the SpO
2
display screen, the display on your
monitor may be looked slightly different.
1. SpO
2
unit;
2. SpO
2
value;
3. SpO
2
alam limit;
4. PI (Perfusion Index) value;
5. PR (Pulse Rate) unit;
6. PR (Pulse Rate) value;
7. PR alam limit.
 Parameters Description
a) Perfusion index(PI) : PI is a value that indicates arterial pulse signal
strength as the percentage of pulsatile signal to non-pulsatile signal. The perfusion
index allows clinicians to place sensors on optimal sites.
9.5 Setting SpO
2
9.5.1 Setting SpO
2
Parameter
Select SpO
2
parameter area to enter SpO
2
parameter setting.
 Setting NIBP measurement on the same limb
When NIBP and SpO
2
are simultaneously measured to the same limb of patient,
4
7
5
2
6
3
1