Patient Monitor User’s manual
1-5
60601-1-1. If in doubt, consult the technical service department or
your local representative.
The operator could not touch these ports and the patient
simultaneously.
1.3 Measurement Modules
The monitor can support the following modules:
IBP module: Invasive Blood Pressure module.
Temp module: Temperature module.
SpO
2
module: Nellcor SpO
2
module, Masimo SpO
2
module.
CO
2
module: Mainstream CO
2
module, sidestream CO
2
module and
microstream CO
2
module.
AG module: Mainstream AG module and sidestream AG module.
Under the condition of maximum configuration, the monitor is equipped
with one 2-slot plug-in box box. Because different measurement modules
occupy different amount of slots, hence the amount of plug-in modules on
the monitor may vary.
1.3.1 Plug and unplug module
The monitor supports hot plug of all modules. That is, you can plug in or
pull out a module when the power of the monitor has not been shut off.
Plug in and pull out of modules
——Plug in module: make a module point to the position of the slot and push
it into the slot until the buckle at bottom of the module clicks into place.
——Pull out module: lift up the buckle at bottom of the module, and pull out
the module and remove it.
——After plugging in a module, please make sure whether the indicating
lamp on the module lights up. If not, please pull out and plug in the
module once more.
To Next Page
Loading...
Need help?
General
