i) Consecutive measurements will cause blood accumulation in the
lower arm which will affect the measuring results. To improve
reading accuracy, raise the arm being measured, squeeze and relax
your hand several times, then take another measurement. Another
option is to take the cuff off and wait at least 5 minutes before
repeating measurement.
j) If this device was stored in low temperature, it is necessary to leave
it in room temperature for at least 1 hour, otherwise the measurement can be inaccurate.
Comment:
Continue to use the same arm for comparisons. It is not unusual for there to be a difference in blood pressure
between arms.
Comparable blood pressure measurements always require the same conditions (Relax for several minutes before
taking a measurement).
ATTENTION: Do not use a cuff other than the original cuff contained in this kit!
3.4 Measuring Your Blood Pressure
After the cuff has been appropriately positioned, the measurement can begin:
1. Press the START/STOP button until all the symbols appear on the screen. You will hear 2 short
beeps and after “ ” will flash for 2 seconds. The pump then begins to inflate the cuff. The
increasing pressure in the cuff is shown on the display.
2. After the suitable pressure has been reached, the pump stops and the cuff gradually deflates.
The cuff pressure will then be displayed. In case the initial inflation is not sufficient, the device
automatically re-inflates to a high pressure.
3. When the device detects a heartbeat, the heart symbol “ ” on the display starts to flash and you
can hear a beep for every heartbeat.
4. When the measurement has been completed, you will hear a long beep and the systolic, diastolic
and pulse rate will appear on the display.
5. The measurement readings remain on the display until you switch off the device. If no button is
pressed, the device switches off itself in 3 minutes.
NOTE: The symbol “ ” will be displayed along with the reading if irregular heartbeat has been
detected during the measurement. If the “ ” symbol appears frequently (e.g. several times a week),
it may be an indication of a more serious heart problem, and you should consult your doctor.
3.5 Discontinuing a Measurement
To stop the measurement (eg. the patient feels unwell) press the START/STOP button. The device will immediately
decrease the cuff pressure automatically.
3.6 Memory Recall
This blood pressure monitor automatically stores 90 measurements for each user in its memory. The oldest record will
be replaced by the latest measurement value when there are more than 90 sets for each user.
3.7 Recall the Memory with the Power Off
Press the “+” or “-” button, the average of the last 3 measurements will be shown, or press the “-” button again to
see the most recent measurement value. Subsequest measurements can be displayed one after the other by pressing
the “+” or “-” button.
i)
To Next Page
Loading...
