Abnormal Blood Pressure Rest for 5 minutes and try measurement again.
Low battery Replace batteries.
If problems occur when using the device the following points should be checked, and if necessary, the corresponding
measures should be taken.
Malfunction Remedy
The display remains blank when the device is
switched on.
1. Check batteries for correct polarity.
2. If using the AC adapter, ensure it is correctly inserted.
The pressure does not rise even though the pump
is running.
Check the connection of the cuff tube and connect properly
if necessary.
The device frequently fails to measure the blood
pressure values, or the values measured are too low
or too high.
1. Check the positioning of the cuff and cuff tension. The
cuff should be snug but not tight.
2. Measure the blood pressure again, ensuring that you
have remained motionless for a sufficient amount of time
to ensure an accurate reading.
Every measurement produces varying results
although the instrument functions normally and the
values displayed are normal.
Note that blood pressure fluctuates continuously; therefore
measurements will show some variability.
Blood pressure values measured differ from those
measured by the doctor.
Record the daily developement of the values and consult
your doctor.
Note: Individuals visiting their doctor frequently
experience anxiety which can result in a higher
blood pressure reading than at home.
For assistance call BIOS Medical Blood Pressure Hotline: 1-866-536-2289
5. Care and Maintenance
a) Do not expose the device to either extreme temperatures, humidity, dust or direct sunlight.
b) The cuff contains a sensitive air-tight bubble. Handle this carefully and avoid all types of
stress through twisting or buckling.
c) Clean the device with a soft, dry cloth. Do not use gas, thinners or similar solvents. Spots
on the cuff can be removed carefully with a damp cloth and soapsuds. The cuff with
bladder must not be washed in a dishwasher, clothes washer, or submerged in water.
To Next Page
Loading...
