EasyManua.ls Logo

BIOS Diagnostics Protocol 7D - Protocol Software (7 D Mode)

BIOS Diagnostics Protocol 7D
19 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
0ROTOCOL3OFTWARE$-ODE
7D Mode is used in consultation with your physician for assessing white coat
hypertension or sustained hypertension, based on a protocol of measurements taken
at home. The protocol calls for 2 measurements to be taken in the morning (AM) and
2 measurements in the evening (PM) for 7-days consecutively. The blood pressure
monitor will automatically average the measurements according to the protocol
and will indicate whether all data was fulfilled, at the proper times. 7D Mode
simplifies the process for users and provides physicians with clear data from home
measurement.
1. When the monitor is OFF, press the SET button, a small triangle will appear above 7D
Mode on the monitor. Press the SET button to confirm.
./4%0RESSTHEhvORhhBUTTONSTOSWITCHBETWEEN$-ODEAND
General Mode.
2. Next, select the user. When taking measurements in 7D Mode it is very important to
select the correct user. Press the SET button to confirm, then press the 34!2434/0
button to power the monitor OFF.
0REPARATIONFORMEASUREMENT
- Rest for 5 minutes before taking a measurement
- Sit at a table with your arm supported and legs uncrossed
- Avoid all movement and muscle tension
- Breathe normally and do not speak
- Wait at least 1 minute between consecutive measurements
- AM & PM measurements should be taken 10-12 hours apart
To start your measurement, see section 3.6 Measuring Your Blood Pressure. Once the Protocol is complete,
after the 7 days, you can view your average. See section 3.8B Recalling Memory in 7D Mode.
)-0/24!.4
)TISCRITICALTHATUSERSFOLLOWTHEMEASUREMENTPROTOCOLCAREFULLYTOENSURERELIABLEDATAFOR
diagnosis.
1. Take 2 measurements in the morning (ideally after going to the bathroom and before eating
or drinking).
2. Take 2 measurements in the evening approximately 10-12 hours after the morning measurements,
and ideally not immediately after the evening meal.
3. Repeat these 4 measurements per day for 7 days consecutively.
./4%-ISSINGMEASUREMENTSWILLCAUSE%22TOAPPEARONTHEDISPLAY#ONTINUEWITHTHE
SEQUENCEOFMEASUREMENTSANDDISCUSSWITHYOURDOCTORWHENYOUREVIEWTHEDATA
./4%4HEMACHINEONLYRECOGNIZES!-AND0-READINGSEACHDAY)TDOESNOTEXCLUDE!-AND
0-MEASUREMENTSONLYAFEWHOURSAPART%ACHMEASUREMENTHASATIMESTAMP$ISCARD
ANYMEASUREMENTSTHATWERENOTATLEASTHOURSAPARTWITHYOURDOCTOR
7D mode General mode

Related product manuals