Malfunction 2EMEDY
The display remains blank when the device is
switched on.
1. Check batteries for correct polarity.
2. If using the AC adapter, ensure it is correctly
inserted.
The pressure does not rise even though the pump is
running.
Check the connection of the cuff tube and connect
properly, if necessary.
The device frequently fails to measure the blood
pressure values, or the values measured are too low
or too high.
1. Check the positioning of the cuff and cuff tension.
The cuff should be snug but not tight.
2. Measure the blood pressure again, ensuring that
you have remained motionless for a sufficient
amount of time to ensure an accurate reading.
Every measurement produces varying results
although the instrument functions normally and the
values displayed are normal.
.OTETHATBLOODPRESSUREmUCTUATESCONTINUOUSLY
therefore measurements will show some variability.
Blood pressure values measured differ from those
measured by the doctor.
Record the daily developement of the values and
consult your doctor.
./4%)NDIVIDUALSVISITINGTHEIRDOCTORFREQUENTLY
EXPERIENCEANXIETYWHICHCANRESULTINAHIGHER
blood pressure reading than at home.
&ORASSISTANCECALLTHE")/3-EDICAL(OTLINE
5. Care and Maintenance
a) Do not expose the device to either extreme temperatures, humidity, dust or direct sunlight.
b) The cuff contains a sensitive air-tight bubble. Handle this carefully and avoid
all types of stress through twisting or buckling.
c) Clean the device with a soft, dry cloth. Do not use gas, thinners or similar
solvents. Spots on the cuff can be removed carefully with a damp cloth and
soapsuds. 4HECUFFWITHBLADDERMUSTNOTBEWASHEDINADISHWASHER
CLOTHESWASHERORSUBMERGEDINWATER
d) Handle the tube carefully. Do not pull on it. Do not allow the tubing to kink
and keep it away from sharp edges.
e) Do not drop the monitor or treat it roughly in any way. Avoid strong vibrations.
f) Never open the monitor. This invalidates the manufacturer’s warranty.
M
START
STOP
M
S
TART
ST
O
P
M
S
TART
ST
O
P
To Next Page
Loading...
