32 | Chapter 3: UEFI BIOS & Soware
Vivid LED DJ
Vivid LED DJ can adjust your color scheme of ARMOR GEAR, RGB LED Device.
1. LED COMMANDER: Allows you to select the LED mode.
• Default : Default LED illuminaons. (Blue light)
• RGB Sync : Allows you to synchronize the LED Type item sengs.
2. LED Type: Select the LED lighng blocks.
• System : System LED illuminaons. (Racing ARMOR)
• 12V LED : The 12V LED illuminaon. (12V_LED Device)
• 5V LED : The 5V LED illuminaon. (5V_LED Device)
• Memory Sync : The RGB Audio LED illuminaon. (Memory LED)
3. ON/OFF: To enable or disable VIVID LED funcon.
4. ON/OFF: Allows you to enable or disable LED of a single item.
5. Auto: LEDs will Automacally change the Color Palee and LED Brightness.
»
»
If you select Auto mode, the Color Pallee and LED Brightness Bar will disabled.
6. LED SPARKLE: Allows to you choose sparkle of the LEDs.
• Permanent: LEDs are constantly lit.
• Shine: LEDs ash at a specic frequency.
• Breath: LEDs gradually ash on and o.
• Shine & Music: LEDs will ash according the music played on your system.
»
»
Please make sure your speaker or earphone is properly connected to audio jack before using
RACING GT EVO program.
• Meteor: LEDs slide at a specic frequency.
• Wave: LEDs are presented in a water wave rhythm.
• Starry sky: LEDs icker at a specic rhythm.
• Lightning: LEDs ash and slide at a specic frequency.
• Rainbow: LEDs lights to dazzling colorful rhythm.
• Aurora: LEDs shows so light and ickers lightly.
7. High/Low Speed Switch: Allows you to control the icker speed.
To Next Page
Loading...
Need help?
General
