Biostar H410MH S2 2.0 User Manual

10 | Chapter 2: Hardware installaon
2.2 Install a Heatsink
Step 1: Place the CPU fan assembly on top of the installed CPU and make sure that the four
fasteners match the motherboard holes. Orient the assembly and make the fan cable is closest
to the CPU fan connector.
Step 2: Press down two fasteners at one me in a diagonal sequence to secure the CPU fan
assembly in place. As each fastener locks into posion a click should be heard.
Note
»
»
Apply the thermal interface material on the CPU before heatsink installaon, if necessary.
»
»
Do not forget to connect the CPU fan connector.
»
»
For proper installaon, please kindly refer to the installaon manual of your CPU heatsink.

Biostar H410MH S2 2.0 Specifications

General

Form Factor	Micro ATX
Chipset	Intel H410
CPU Socket	LGA 1200
Memory Type	DDR4
Memory Slots	2
Maximum Memory	64GB
Memory Standard	DDR4 2933/2666/2400/2133
PCIe x16 Slots	1
PCIe x1 Slots	2
SATA III Ports	4
LAN	Realtek RTL8111H
Video Outputs	HDMI, VGA
M.2 Slot	1 x M.2 Key M Socket, supports M.2 Type 2280 SATA3 6.0Gb/s SSD
Audio	Realtek ALC887
USB 3.2 Gen1	4 (2 rear, 2 via headers)
USB 2.0	6 (2 rear, 4 via headers)