Biostar H410MH S2 2.0 User Manual

Chapter 1: Introducon | 3
H410MH S2 2.0 | H510MHP 2.0 | B560MHP 2.0
Chapter 1: Introducon
1�1 Before You Start
Thank you for choosing our product. Before you start installing the motherboard, please make
sure you follow the instrucons below:
• Prepare a dry and stable working environment with sucient lighng.
• Always disconnect the computer from power outlet before operaon.
• Before you take the motherboard out from an-stac bag, ground yourself properly
by touching any safely grounded appliance, or use grounded wrist strap to remove the
stac charge.
• Avoid touching the components on motherboard or the rear side of the board unless
necessary. Hold the board on the edge, do not try to bend or ex the board.
• Do not leave any unfastened small parts inside the case aer installaon. Loose parts
will cause short circuits which may damage the equipment.
• Keep the computer from dangerous area, such as heat source, humid air and water.
• The operang temperatures of the computer should be 0 to 45 degrees Celsius.
• To avoid injury, be careful of:
Sharp pins on headers and connectors
Rough edges and sharp corners on the chassis
Damage to wires that could cause a short circuit
1.2 Package Checklist
• Serial ATA Cable x2
• Rear I/O Panel for ATX Case x1
• Quick Installaon Guide x1
• Fully Setup Driver DVD x1
Note
»
»
The package contents may be dierent due to the sales region or models in which it was sold. For
more informaon about the standard package in your region, please contact your dealer or sales
representave.

Biostar H410MH S2 2.0 Specifications

General

Form Factor	Micro ATX
Chipset	Intel H410
CPU Socket	LGA 1200
Memory Type	DDR4
Memory Slots	2
Maximum Memory	64GB
Memory Standard	DDR4 2933/2666/2400/2133
PCIe x16 Slots	1
PCIe x1 Slots	2
SATA III Ports	4
LAN	Realtek RTL8111H
Video Outputs	HDMI, VGA
M.2 Slot	1 x M.2 Key M Socket, supports M.2 Type 2280 SATA3 6.0Gb/s SSD
Audio	Realtek ALC887
USB 3.2 Gen1	4 (2 rear, 2 via headers)
USB 2.0	6 (2 rear, 4 via headers)