NF520-A2 TE/NF520-A2 SE/NF520-A2
1
CHAPTER 1: INTRODUCTION
1.1 BEFORE YOU START
Tha nk yo u for choo sing our product. Before you start installing the
mo the rboa rd, plea se make su re you fo llow the ins tructions be lo w:
Prepare a dry and stable working environment with
s ufficie nt ligh ting .
Always disconnect the computer from power outlet
be fo re ope ra tion .
Befo re you take the mo the rboa rd ou t f rom a n ti-s ta tic
bag, ground yourself properly by touching any safely
grounde d appliance, or use grounded wrist strap to
remove the static charge.
Avo id tou ch ing the com pone nts o n mo the rboa rd o r the
rear side of the board unless necessary. Hold the board
on the edge , do not try to be nd or flex the board.
Do not lea ve any unfastene d sma ll parts inside the
case after installation. Loose parts will cause short
circuits which may damage the equipment.
Keep the computer from dangerous area, such as heat
source, humid a ir and wa ter.
1.2 PACKAGE CHECKLIST
HDD Cable X 1
Se ria l ATA Cab le X 1
Rear I/O Panel for ATX Case X 1
Use r’s Ma nual X 1
Fully Setup Driver CD X 1
FDD Cable X 1 (optional)
USB 2.0 Cable X1 (optional)
S/P DI F ou t Ca ble X 1 (op tiona l)
Se ria l ATA Po we r Cab le X 1 (o ptio nal)
Note: The package contents may differ by area or your motherboard version.
To Next Page
Loading...
